3. Software installation and use
NASUM supports the most popular LaserGRBL software,
LaserGRBL is an open source, easy to use and powerful software, but
unfortunately LaserGRBL only supports Windows (Win XP / Win 7 / Win
8 / XP / Win 10).
For Mac users, of course, you can choose LightBurn, which is also an
excellent engraver software, but this software needs to pay for $40. This
software also supports Windows.
The NASUM A5/A5 PRO engraver receives commands from the
computer to move. The engraver needs to stay connected to the computer
and cannot turn off the engraver software (LaserGRBL or LightBurn)
during the engraving process . Since the calculations are done on the
computer, the configuration of the computer will affect the speed and even
the quality of the engraving.
The following section will focus on the installation and use of the
LaserGRBL software. LightBurn will briefly explain the installation and
configuration process.
3.1 LaserGRBL Software Installation and Use
1. Downloading software
LaserGRBL is one of the most popular DIY laser engraving software
in the world, LaserGRBL download website:
http://lasergrbl.com/download/
To Next Page
Loading...