National Office Furniture Waveworks User Manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Assembly Instrucon
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
Part # 3156186
Rev, -
Printed in U.S.A
© 2014 Kimball International, Inc.
1
Waveworks
Locker Units
Tools Required
Drill (Phillips #2)
2
Vercal Storage Lockers can be used in open oorplan conguraons
if they are ganged side-by-side in sets of 2 (or more) or back-to-back
in sets of 4 or more. See acceptable conguraons below. The end
panels and/or back panels of the units must be screwed together in
these applicaons. The recommended screw length for ganging units
is a 1-1/4” and there should be at least 2 screws per aachment face.
FIGURE B– Acceptable
FIGURE A- Acceptble
Start by leveling the units in their intended locaon, follow the leveling
guide (ref dwg# 1399193,- ). If necessary, adjust the door hinges following
the guide (ref dwg# 1475186,-).
FIGURE C– Not Acceptble

National Office Furniture Waveworks Specifications

General

Category	Indoor Furnishing
Brand	National Office Furniture
Product Line	Waveworks
Material	Wood, Metal
Dimensions	Varies by product
Weight Capacity	Varies by product
Adjustability	Varies by product
Warranty	Varies by product
Finish	Various finishes available

Summary

Assembly Instructions

Leveling and Door Adjustment

Instructions for leveling units and adjusting door hinges for proper setup and alignment.

Ganging and Configuration Options

Details on joining lockers side-by-side or back-to-back for various configurations.

Wall Mounting and Safety

Mounting to Structural Walls

Guidelines for mounting lockers against structural walls using anti-tip kits.

Approved Wall Restraints

Specifies approved anti-tipping restraints meeting ASTM F3096-14 and F2057-17 standards.