National CS-A95KA - Preparation before Operation; G Indoor Unit

11
PREPARATION BEFORE OPERATION
 !"
! Warning / 
■ Ensure the power plug is securely inserted.
A loose plug may cause a fire or an electric shock.
■  !"#$%&"'(
 !"#$%&'()*+,
5
Insert the air filters
 !"
4
Insert the air purifying filters
 !"#$%&
1 Connect the power supply
cord to an independent
power supply
 !"#$%&'(

3 Remove the air filters
 !"
2 Open the front panel
 !"
6
Close the front panel
 !"
■ Notes

• If the unit is not going to be used for an extended period of time, turn off the power supply. If it is left at the ON
position, approximately 2.5 W of electricity will be used even if the indoor unit has been turned off with the remote
control.
• If operation is stopped, then restarted immediately, the unit will resume operation only after 3 minutes.
•  !"#$%&'()*+,-./012345678"9lk !"#$%&'()*+,-./0%
 !"#=OKR=t= !
•  !"#$%&'()*$+,-./0=P= !"#$%
● Indoor Unit

DBT: Dry Bulb Temp
 !
WBT: Wet Bulb Temp
 !
Maximum Temperature
 !
Minimum Temperature
 !
DBT WBT DBT WBT DBT WBT DBT WBT
32 23 43 26 30 – 24 18
16 11 16 11 16 – -5 -6
Use under the following conditions
 !"#$
(Unit in °C)
 !"#
Indoor

Outdoor

Indoor

Outdoor

Cooling /  Heating / 
P
O
W
E
R
E
C
O
N
O
M
Y
P
O
W
E
R
F
U
L
S
L
E
E
P
T
IM
E
R