Native Instruments O Kore 2 - Page 122

KORE 2 – 122
hits. Activate the P re -l iSten button to start the function. This will load
the currently selected KoreSound from the S earCH r eSultS l iSt into the
currently selected CHannel inSert on the Sound Matrix. Use your MIDI
keyboard or a sequencer track to listen to the sound.
If you keep the Pre-liSten function active and select a different KoreSound
from the Search Results List, it will immediately be loaded into the same
CHannel inSert as the previous sound. If you switch off the Pre-liSten
function the C Hannel i nSert returns to the state it was before the activation
of the P re -l iSten function. This means it either contains the KoreSound
it had before or it is empty as before. The button to the right of the Pre-
liSten button is the Pre-liSten aPPly command. By clicking this button
while in Pre-liSten mode you acknowledge the loading of the pre-listened
KoreSound, leave the Pre-liSten mode and keep the last heared KoreSound
in the C Hannel i nSert . You can toggle P re -l iSten on or off via the keyboard
shortcut Ctrl+p.