Native Instruments O Kore 2 - Page 155

KORE 2 – 155
3.8.15 Gate
Apart from the classic studio use as a noise gate, this effect has a large
number of application areas including chopping up beats using the lter
for gating dened frequency ranges.
Label Function Range Unit
Mix
Controls the balance between the dry, unprocessed signal (at the left) and the wet, pro-
cessed signal (at the right).
0..100 %
Detector Filter
Low Cut
Cutoff frequency of the 2-pole high pass lter of the level detector. Can be used to avoid
opening of the gate by low frequencies.
10…5000 Hz
Detector Filter
Hi Cut
Cutoff frequency of the 2-pole low pass lter of the level detector. Can be used to avoid
opening of the gate by high frequencies.
100..20000 Hz
Threshold Sets the level at which the Gate opens. -80..10 dB
Hysteresis Determines by how much the threshold for closing is lower than the threshold for opening. 0..20 dB
Attack Sets the time it takes for the gate to open. 0..200 ms
Hold Controls the time the gate will stay open, regardless of the signal falling below threshold. 0..1000 ms
Release
This is the time the Gate takes to close completely after the signal has fallen below
threshold.
0..2000 ms