KORE 2 – 159
3.8.18 Harmonic Shaper
The HarMoniC SHaPer is a versatile processor that covers a wide range
of waveshaping application areas. You can use it as an Exciter, adding
subtle harmonic content to signals that sound too dull. It can also produce
nice tape- and tube-saturation effects. When fed with simple, synthetic
waveforms, it works as a classcial waveshaper, leading to a variety of
different tones. A great deal of its exibility lies in the fact that you can
exclude low-frequency content from being processed via the S
Plit
F
reQuenCy
control.
Label Function Range Unit
Mix
Controls the balance between the dry, unprocessed signal (at the left) and the
wet, processed signal (at the right).
0..100 %
Split
Frequency
The input signal is split into two frequency bands, the lower of which is not
processed by the waveshaper. You can mix it into the shaped signal via the Tone
control.
15..1500 Hz
Drive Gain
Controls the gain at the input stage of the waveshaper. This sets the amount of
non-linearity.
-24..+24 dB
To Next Page
Loading...
