KORE 2 – 164
3.8.21 Mic Conditioner
The MiC Conditioner assists you when you plug a microphone directly
into KORE 2. Use it to manipulate phase, lter out unwanted low-frequency
content and correct phase shifts between channels via the two delay
lines. Furthermore, the M
iC
C
onditioner
provides facilities for working on
recordings produced by the mid-side recording technique. This is a special
way of stereo recording that allows manipulation of the stereo width after
the recording process.
Label Function Range Unit
Invert L/R Inverts the phase of the left or right channel, respectively. On/Off
High-pass L/R Switches the high-pass lter for the respective channel on or off. On/Off
High-pass Frequency Sets the threshold below which the incoming signal is attenuated. 10..500 Hz
High-pass Poles
Crossfades between a 2-pole and a 4-pole lter. The number of poles denes
the steepness of the lter cutoff slope: At low values the 2-pole setting is used
with a transition band slope of 12 dB per octave; at high values the 4-pole set-
ting provides a slope of 24 dB per octave.
0..6
Left/Right Delay Coarse Controls the coarse delay time for the respective channel. 0..495 ms
To Next Page
Loading...
