KORE 2 – 166
Label Function Range Unit
Mix
Controls the balance between the dry, unprocessed signal (at the left) and the
wet, processed signal (at the right).
0..100 %
Delay Time Sets the effect unit’s initial delay time. The internal LFO modulates this value. 0..1500 ms
Delay Time LR Offset
Controls the delay time balance as a percentage of the initial delay time. Nega-
tive values decrease the left delay time while the right delay increases by the
same amount. Positive values create the opposite effect.
-33..+33 %
Modulation Sync Synchronizes the frequency of the LFO to KORE 2’s timebase. On/Off
Modulation Rate Adjusts the delay time modulation speed, i.e., the internal LFO’s frequency. 0..10 Hz
Modulation Depth Sets the amount of modulation as a percentage of the delay time. 0..100 %
Modulation LR Phase
Sets the phase offset of the LFO modulating the right or left channel delay
times, respectively. At the maximum setting the LFO signal is 180° out of
phase.
0..180 De-
grees
Feedback Amount Sets the level of the delayed signal that feeds back to the effects input. 0..100 %
Cross Feedback
Sets the level of the delayed signal that feeds back into the opposite channel
(i.e., the left channel’s output into the right channel’s input and vice versa), as a
percentage of the main feedback amount.
0..100 %
Inverse Feedback Turns the feedback signal phase inversion on or off. On/Off
Filter Low/High Cut
Sets the cutoff frequency of the low pass/high pass lters that modify the de-
layed signal. Frequencies below/above are attenuated with a slope of 12 dB per
octave.
10..5000/
100..25000
Hz
To Next Page
Loading...
