Native Instruments O Kore 2 - Page 196

KORE 2 – 196
Repeat and Force
The StePS knob in the rePeat section only works in combination with the
PitCH knob. The concept is that the complete Arpeggio is repeated up to
seven times (dened by the value of the S tePS dial) and every repetition is
transposed by a number of semitones dened by the PitCH knob. You can
transpose up to one octave up or down.
The basis of the Arpeggiator is its note buffer. You can think of it as storage
with a capacity of eight notes. The notes you play on your keyboard or
that are fed into the plug-in from a sequencer are stored and reproduced
according to the settings you specify. A traditional Arpeggiator only repeats
the sequence of notes you feed it and this is also the default behaviour
of KORE 2’s Arpeggiator. But with the r ePeat and F orCe parameters the
repertoire of patterns is greatly expanded.