KORE 2 – 224
adapted to the needs of the particular Ensemble. This should be done in
Reaktor stand-alone, for convenience. stand-alone, for convenience.
As a rst step, the local list(s) of the instrument(s) have to be prepared.
Execute the Sort and Compress IDs command from the instrument’s prop-Sort and Compress IDs command from the instrument’s prop- command from the instrument’s prop-
erties. Then set the MAX ID value to the number of MAX ID IN USE valueMAX ID value to the number of MAX ID IN USE value value to the number of MAX ID IN USE value
to make sure that no parameter is masked from the global list. After
doing this for each instrument within the Ensemble use the InstrumentInstrument
Up and Instrument Down commands to position the instruments within and Instrument Down commands to position the instruments withinInstrument Down commands to position the instruments within commands to position the instruments within
the global list. Perhaps it might be useful to use the Ensemble’s signal
ow as a template for the instrument’s order within the global parameter
list. Finally check whether the most important parameters use GLOBALGLOBAL
ID values below 1000, as this is the maximum number of parameters values below 1000, as this is the maximum number of parameters
supported by most plug-in protocols. Here, once more it is important to
remember that changing the IDs causes incompatibility to prior automa-
tion assignments within a host. The changed Ensemble should be saved
with a new lename.new lename..
To Next Page
Loading...
