KORE 2 – 226
KoreSound references the Ensemble le. If the path to the Ensemble is
changed, KORE 2 2 won’t nd it.
KONTAKT
If you want to automate parameters of KONTAKT in a host environment,
you have to assign them to KONTAKT’s Automation Table. Refer to the
KONTAKT manual for more information. You might also want to read
the previous chapter: It focuses on REAKTOR, but discusses general
questions.
The Presets of KONTAKT cannot be changed via the host software, i.e.
KORE 2.
GUITAR RIG
If you have the same module more than once in a GUITAR RIG stack, only
the one loaded rst will be automatable by the VST host.
BATTERY
BATTERY does not expose any of its parameters to the host software. The
Presets of BATTERY cannot be changed via the host.
To Next Page
Loading...
