KORE 2 – 57
Hardware Options
The Hardware Options screen mirrors the parameters from the KORE 2
Controller’s Options Menu.
touCH SenSitiVity allows you to adjust the sensitivity of the eight touch-
sensitive knobs. If set to zero the touch sensor is inactive.
S
MootHing
integrates (from a mathematical standpoint) the data created
by knob movements for a “smoother” feel.
C
ontraSt
sets the ratio of light to dark in the display to compensate for
different lighting conditions.
BaCKligHt controls the display’s brightness.
reFreSH rate determines how often the state of the LEDs and the
display’s contents are updated.
inVert diSPlay changes the default red on black lettering to black
lettering on a red background.
led BrigHtneSS low adjusts the brightness of the LED ring around
the knobs for the off/untouched state. Note that for unassigned or
deactivated controls the LED is switched off completely.
led B
rigHtneSS
H
igH
is the corresponding brightness control for the
on/touched state of the controls.
The Pedal reCaliBrate command is for calibrating any connected pedals
(see below).
Calibration of pedals
If you get the feeling that your connected pedals start to act funny, use
the reCaliBrate command from the hardware options.
►
►
►
►
►
►
►
►
►
To Next Page
Loading...
