Need help?Do you have a question about the Native Watercraft Propel Pedal drive and is the answer not in the manual?
General| Brand | Native Watercraft |
|---|---|
| Model | Propel Pedal drive |
| Category | Boating Equipment |
| Language | English |
Secure the thwart tube to the clamp using the 4mm hex wrench.
Attach the left and right crankarms to the main drive unit.
Mount the completed propel assembly into the kayak's drive box.
Secure the propel unit in the drive box using the slider latch.
Rinse the propel drive with a water hose after each use, especially in saltwater.
Inspect and tighten the drive unit covers to ensure they are flush with the frame.
Apply grease to the upper gears through the grease port using a grease gun.
Grease the propeller gear and the lower transmission gear on the cartridge.
Replace the propeller's shear pin to prevent drive shaft damage.
Includes a replacement propeller and two shear pins for the drive.
Kit for maintaining the propel gear system with Teflon lubricant and tools.
To Next Page