Nature Power 21030 - User Manual

8 pages

Save Page as PDF

To Next Page

SAVE THESE INSTRUCTIONS

Hanging Solar Shed Light

User Manual

WARNING: Read carefully and understand all ASSEMBLY AND OPERATION

INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety

precautions may result in serious personal injury.

Item #21030

V1.1-M 1Jun2018

Main Page

Questions and Answers

L
llaneJul 28, 2025
What to do if my Nature Power 21030 Lantern does not turn on?
- V
  veronicamooreJul 28, 2025
  If your Nature Power Lantern doesn't turn on, it might be due to several reasons. First, the batteries may not be charged, so place the solar panel where it can get maximum sunlight and let it charge for two sunny days with the light switched to the 'ON' position (but turned off via remote). Alternatively, the switch might be in the wrong position; try setting it to 'ON' to control the light with the remote or 'AUTO,' which only activates in darkness. If neither works, the rechargeable batteries might be worn out and need replacement with the same type and size, following the provided instructions. Also, when in 'AUTO' mode, daylight or other light sources can affect the sensor, so switch to 'ON' to control with the remote.
A
andrew68Aug 10, 2025
Why does my Nature Power 21030 Lantern light flash or not stay on for long?
- T
  tranjeffreyAug 10, 2025
  If your Nature Power Lantern light doesn't stay on as long as it used to, or if it flashes, the batteries might not be fully charged. To resolve this, make sure the solar panel is placed where it gets the most sunlight during the day. Turn the light to the ON position and turn off the light by remote control, and allow the solar panel to charge the batteries for two sunny days. Another cause might be that the solar panel isn't receiving enough sunlight to recharge the batteries, so try cleaning the solar panel with a clean, damp cloth. Also, during winter, reduced sunlight can affect battery recharge, so ensure the solar panel is in a sunny spot, remove any shade, and tilt the panel to face the sun directly.