Thank You
Thank You for the purchase of your TR-1 Gold wireless remote. Developed
with the sherman in mind, the TR-1 wireless remote has been designed to
give shermen that competitve edge in shing and unparalleled precision and
control of their boat. Nautamatic Marine Systems,Inc. is dedicated to create
the nest controls and guidance systems for the best in boating and shing.
Safety
You are responsible for the safe and prudent operation of your vessel. Your
TR-1 Gold autopilot and wireless remote is a tool that will enhance your
capability to operate your boat and catch sh. It does not relieve you from the
responsibility for safe operation of your vessel. You must avoid hazards to
navigation and never leave the helm unattended.
You must always be prepared to promptly regain manual control of your
kicker. The autopilot steering and throttle actuators can fail and hard over.
Learn to operate your autopilot on calm and hazard free waters.
Simultaneous operation of several radio-controlled autopilots in near
proximity may cause the autopilot to fail to respond to keypad button presses.
The near boat transmitter may jam your boat’s receiver but will not control
your autopilot or render the wired remote useless.
The Wireless remote will not respond as quickly to multiple button presses as
the wired remote.
On occasion, the wired remote will erroneously leave an indicator light on
the throttle up/down and idle resume indicators. If this creates a problem for
you, we can load an updated software version on your ECU to eliminate the
erroneous indicators.
There is a remote possibility that talking on a cellphone may interfere
with, and possibly jam the radio receiver. Please use caution.
Note:
The wireless remote keypad is not waterproof. Do not expose the remote
to rain or water spray. Water in the remote will cause it to malfunction
and possibly cause throttle runaway. In the event the remote does get
wet, remove the battery from the remote immediately. If the remote is
subject to salt-water incursion, remove the battery and gently rinse the
disassembled unit with clean alcohol and let it dry out before re-assembly
and reuse.
1
To Next Page
Need help?
General