Nautyl PHCP110 - User Manual

Questions and Answers

P
Pamela GrayAug 9, 2025
What to do if my Nautyl Swimming Pool Pump is not starting?
- B
  Bailey RuizAug 9, 2025
  If your Nautyl Swimming Pool Pump isn't starting, first, ensure that the main power is on; if it was off, wait for it to be reinstated. Next, check if the switch is off and switch it on. Also, inspect the fuse; if it's burnt out, replace it. Finally, see if the circuit breaker has tripped; if so, switch it back on.
J
jenningsbonnieAug 17, 2025
Why Nautyl Swimming Pool Pump has air outlet but heating is not satisfactory?
- M
  Martha HarringtonAug 17, 2025
  If you notice air coming out of your Nautyl Swimming Pool Pump but the heating isn't sufficient, there might be a few reasons: * The air inlet could be blocked, so clean out the stem. * The air outlet might be obstructed; in this case, clean out the stem as well. * The unit could be in a 3-minute time lag protection mode, so please wait. * The temperature setting may be too low; increase the temperature setting accordingly.
C
Craig HayesAug 25, 2025
Why is my Nautyl Heat Pump blowing air but not heating properly?
- D
  Dr. Kevin BrownAug 25, 2025
  If your Nautyl Heat Pump isn't providing sufficient heat despite airflow, check for these possible causes: * The air inlet might be blocked. Clear any obstructions. * The air outlet could be obstructed. Clear any blockage. * The temperature setting may be too low. Increase it to your desired level. * The unit may be in a 3-minute time lag protection mode. Please wait for it to complete.
E
Edward WebbAug 31, 2025
What to do if Nautyl Heat Pump is not starting?
- M
  Michael SandersAug 31, 2025
  If your Nautyl Heat Pump isn't starting, check the following: * Ensure the main power is on. If it's off, wait for the power to be restored. * Verify the unit is switched on. * Check for a burnt-out fuse and replace it if necessary. * See if the circuit breaker has tripped and switch it back on.