Naxa NTD-1956 - User Manual

Questions and Answers

L
Laura YoungAug 18, 2025
What to do if my Naxa NTD-1956 TV has no picture or distorted picture?
- M
  Michael JohnsonAug 18, 2025
  If there's no picture, the picture is distorted, or the buttons aren't working, the remote control might need new batteries. Install two new “AAA” batteries. Also, ensure there are no obstructions between the remote and the sensor on the front of the unit. A scratched, dirty, or warped disc may be unplayable. Try cleaning the disc. Static electricity could also be interfering; in that case, switch off and unplug the unit, then reconnect and switch it on again.
A
Andrew VargasAug 20, 2025
Why my Naxa TV can't play a disc?
- K
  Karen NielsenAug 20, 2025
  If your TV can't play a disc, first check that the disc is placed correctly in the disc tray with the label side facing up. The disc might be incompatible; check the “About Optical Discs” section of the manual to ensure it meets the compatibility requirements. Also, the disc could be dirty or damaged. Try cleaning it, but if it's too scratched or damaged, it may be unplayable.
C
Cody JordanAug 23, 2025
How to troubleshoot a Naxa TV that will not turn on?
- J
  Joshua AndersonAug 23, 2025
  If the unit won't turn on, ensure the AC or DC power cord is securely connected and that the outlet is providing power.
S
sblackburnAug 26, 2025
Why is there no sound on my Naxa TV but the picture is fine?
- R
  Richard WilsonAug 26, 2025
  Make sure the MUTE function is not enabled and try increasing the volume level.
A
Amanda AnthonyAug 28, 2025
How to adjust picture settings on my Naxa NTD-1956 TV?
- B
  Bradley KlineAug 28, 2025
  Press P.MODE to try a different picture preset, or adjust the contrast and brightness options manually in the TV System Setup menu.
G
gwilsonAug 31, 2025
How to fix a snowy picture on my Naxa TV?
- S
  Sarah LewisAug 31, 2025
  Adjust the antenna or install an antenna amplifier.
C
Carmen SmithSep 2, 2025
Why is the picture wavy on my Naxa TV?
- D
  dunnnicholasSep 2, 2025
  Wavy patterns are usually caused by nearby radio transmitters or other devices interfering with reception. Turn off other devices in the area.
T
Tanya MillerSep 4, 2025
How to correct a doubled or ghosty picture on my Naxa NTD-1956?
- J
  Joseph PettySep 5, 2025
  Adjust the direction of the antenna, or try to elevate it.
M
Molly PerrySep 7, 2025
How to ensure my Naxa NTD-1956 TV antenna is properly connected?
- M
  Michael HendersonSep 7, 2025
  Ensure that the RF IN antenna/cable connection is secure.
S
Steven JonesSep 9, 2025
What to do if a Naxa NTD-1956 channel is not broadcasting correctly?
- E
  Elizabeth ZimmermanSep 9, 2025
  Try the station again later, or try a different station.