Neary 555 User Manual

1
This book consists of two manuals:
The OPERATORS MANUAL which contains all the
information on operating and doing routine daily
maintenance on this equipment.
The ASSEMBLY and SERVICE MANUAL which is
used by the maintainence department to install the
equipment and to do all maintenance except routine
daily maintenance.
555
AUTO - INDEX
SPIN / RELIEF
REEL GRINDER

Neary 555 Specifications

General

Brand	Neary
Model	555
Category	Grinder
Language	English

Summary

Safety Instructions

Warning Decals

Details warning decals on the grinder for hazard identification.

Daily Maintenance by the Operator

Getting to Know Your Grinder

Specifications

Provides technical specifications for the grinder, including dimensions and power.

Control Panel Component Identification

Identifies and describes the function of each control panel component.

Front and Rear Mower Mounting

Details the procedure for mounting front and rear mower units onto the grinder.

Reel Position

Guides on positioning the reel relative to the grinding wheel for optimal grinding.

Traverse Engagement and Release

Explains how to engage and release the traverse mechanism for grinding.

Traverse Proximity Sensors

Describes the function and adjustment of traverse proximity sensors.

Spin/Relief Grinding Head

Details the spin and relief grinding head components and setup.

Relief Angle Adjustment

Guides on adjusting the relief angle of the grinding system.

Relief Wheel Diameter Adjustment

Explains how to adjust the finger system for grinding wheel wear.

Index Finger Adjustments

Details the adjustment procedure for the index finger for automatic relief.

Alignment Gage

Explains the use of the digital alignment gage for reel setup.

Operating Instructions

Prepare Mowing Unit for Sharpening

Outlines preparatory steps for sharpening a mowing unit.

Lifting Reel Into Position

Describes methods for lifting reels into the grinder, including kits and workstations.

Install Reel

Step-by-step guide for installing the reel into the grinder.

Align the Reel

Details the process of aligning the reel for accurate grinding.

Checking for Taper

Explains how to check for and measure taper in the reel.

Alignment of Grinding Shaft to Reel

Describes how to align the grinding shaft with the reel for proper grinding.

Setting the Traverse Limits

Guides on setting the traverse limits for the grinding wheel.

Attaching the Variable Speed Spin Drive Unit to the Reel

Details the procedure for attaching the spin drive unit to the reel.

Setup Procedure for Spin Drive RPM Versus Transverse Speed

Outlines the setup procedure for spin drive RPM and traverse speed.

Compensating for Taper

Explains how to compensate for reel taper during the grinding process.

Spin Grinding

Step-by-step instructions for performing the spin grinding operation.

Relief Grind

Details the procedure for performing the relief grinding operation.

Reel Spiral

Guides on identifying whether a reel has a normal or reverse helix.

Wheel Dressing

Instructions on dressing the grinding wheel to maintain its effectiveness.

Normal Helix

Specific instructions for dressing the grinding wheel for normal helix reels.

Reverse Helix

Specific instructions for dressing the grinding wheel for reverse helix reels.