NEC 4xi NEC - Page 10

Extron • System 4
xixi
xixi
xi Switcher Series • User’s Manual • P/N 68-413-02 Rev. E
NEC Installation Configuration and Connections
Page 10
5. The NEC Com Adapter (26-494-01) has two male connectors, one 9-pin and one
15-pin. Plug the 15-pin male connector to the female connector marked
“REMOTE 2/PC” on the NEC connector panel.
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
(shown as CC 50') into the PJ Comm port on the System 4xi. The other end has
a 9-pin female connector. Plug this into the other 9-pin male D connector on the
NEC COM adapter.
______ Secure all of the connector screws.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV
cable onto the System 4xi output and those on the other end onto the matching
BNCs on the NEC connector panel. See cable diagram.
8. Power up the projector and set the projector as follows:
• if your system has less than 10 inputs, set the projector to SW_Level 1 mode
• if your system has 10 or more inputs, set the projector to SW_Level 2 mode
9. Apply AC power to the System 4xi.
System 4
xixi
xixi
xi - NEC GT 2000 Projector Connections
Use the diagram below as a guide when connecting the System 4xi to the NEC
GT 2000 Projector. Refer to NEC documentation to continue the installation.
Connecting the System 4xi to the NEC GT 2000 Projector
____________ In a rack mount, do NOT allow the weight of the cables to be supported by the
System 4 xi . See page 2-5 for cabling guidelines.
__________ System 4 xi channel numbers correspond to the projector’s “Group” numbers.
RGBHV 5 BNC
15-Pin
Male
9-Pin Female
CC 50'
9-Pin Male
COM Adapter
P/N 26-494-01
"K"
15-Pin Male
OUTPUT
PJ COMM
RS 232
AUDIO AUDIO AUDIO AUDIO AUDIO
H/HV
R/C G/Y BR/C G/Y B
V
INPUT 4
H/HV V
R/C G/Y B
INPUT 3
H/HV V
R/C G/Y B
INPUT 2
H/HV V
R/C G/Y B
INPUT 1
H/HV V
○ ○ ○ ○○○○○○○○
○○○○○○○○○○○○
○ ○ ○○○○○○○○○○○○○○○○○○○○○○○○○