-7- Setup
Battery
To Insert the Battery
Ensure that your handset is switched off before you insert the battery. Place the bottom of the battery into position and then
push down on the upper section of the battery until it clicks into place.
The battery can also be charged whenever you wish without affecting the performance of the handset.
Your e313 automatically switches off if the battery voltage is too low.
Batteries have a lifecycle. If you find that the amount of times you have to charge the battery is increasing dramatically,
the battery life may be coming to an end. Replace the battery with a new one of the same type.
When the battery is not being used for a long period, remove it from your e313 and store in a place with low humidity
and low temperature.
A battery that has not been used for a long period of time needs to be completely discharged and then recharged two or
three times before reaching full capacity.
Charging
To Charge the Battery Using the Charger
1 Make sure that the battery is attached to your handset.
2 Connect the charger plug to your e313 I/O connector. See the diagram on the next page.
3 Plug the charger into a power socket. The LED indicator on your e313 will light up when charging is in progress and go
off when charging is completed.
4 After charging the battery, tilt the charger plug upward and pull it away from your e313 I/O connector.
To Next Page
Loading...
