NEC M350X - Page 123


7. Maintenance
 2EPLACETHEFOURlLTERS
1. Remove the filter, and then clean the filter unit and the filter cover.
2. Attach new filters.
Filter unit: Attach two honeycomb filters (coarse mesh) to the filter unit.
Filter cover: Attach two accordion filters (fine mesh) to the filter cover.
The accordion filter has slits on it. Align these slits with the protrusions of the filter cover.
 !TTACHTHElLTERCOVERBACKTOTHElLTERUNIT
Align the filter unit with the filter cover and push the protrusions into place.
s-AKESUREALLSIXMOUNTINGPOINTSAREALIGNEDPROPERLY
 0UTTHElLTERUNITBACKTOTHEPROJECTORCABINET
Insert two catches of the tip of the filter unit into the groove of the cabinet.
 0USHTHElLTERUNITUNTILITCLICKSINTOPLACE
WIRELESS
WIRELESS
4HISCOMPLETESTHElLTERREPLACEMENT
'OONTOTHECLEARINGLAMPANDlLTERHOURMETERS
4OCLEARTHELAMPUSAGEHOURSANDTHElLTERUSAGEHOURS
 0LACETHEPROJECTORWHEREYOUUSEIT
 0LUGTHEPOWERCORDINTOTHEWALLOUTLETANDTHENTURNONTHEPROJECTOR
 #LEARTHELAMPUSAGEHOURSANDTHElLTERUSAGEHOURS
1. From the menu, select [RESET] m [CLEAR LAMP HOURS] and reset the lamp usage hours.
2. Select [CLEAR FILTER HOURS].and reset the filter usage hours. (m page 91)