NEC M350X - After Use Procedures


2. Projecting an Image (Basic Operation)
 After Use
0REPARATION-AKESURETHATTHEPROJECTORISTURNEDOFF
 5NPLUGTHEPOWERCORD
 $ISCONNECTANYOTHERCABLES
s 2EMOVETHE53"MEMORYIFITISINSERTEDINTOTHEPROJECTOR
 2ETRACTADJUSTABLETILTFOOTIFEXTENDED
 3LIDETHELENSCOVERTOTHERIGHTTOCOVERTHELENS
 0UTTHEPROJECTORANDACCESSORIESINTHESUPPLIEDSOFTCASE
Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from
damage.
./4%7HENPLACINGTHEPROJECTORINTHESOFTCASERETRACTTHETILTFOOTANDTHEREARFEET&AILURETODOSOMAYCASEDAMAGETOTHE
PROJECTOR
CAUTION:
5SECAUTIONWHENPUTTINGTHEPROJECTORINTHESOFTCASEIMMEDIATELYAFTERTHEPROJECTORHASBEENOPERATING4HE
PROJECTORCABINETISHOT
Insert the projector with the lens
facing upward