NEC M350X - Page 90


5. Using On-Screen Menu
3ELECTING#OMMUNICATION3PEED;#/--5.)#!4)/.30%%$=
4HISFEATURESETSTHEBAUDRATEOFTHE0##ONTROLPORT$3UB0)TSUPPORTSDATARATESFROMTOBPS4HE
DEFAULTISBPS3ELECTTHEAPPROPRIATEBAUDRATEFORYOUREQUIPMENTTOBECONNECTEDDEPENDINGONTHEEQUIP-
MENTALOWERBAUDRATEMAYBERECOMMENDEDFORLONGCABLERUNS
./4%9OURSELECTEDCOMMUNICATIONSPEEDWILLNOTBEAFFECTEDEVENWHEN;2%3%4=ISDONEFROMTHEMENU
3ETTING)$TOTHE0ROJECTOR;#/.42/,)$=
9OU CANOPERATEMULTIPLEPROJECTORSSEPARATELYANDINDEPENDENTLYWITHTHESINGLEREMOTECONTROLTHATHASTHE#/.42/,
)$FUNCTION)FYOUASSIGNTHESAME)$TOALLTHEPROJECTORSYOUCANCONVENIENTLYOPERATEALLTHEPROJECTORSTOGETHER
USINGTHESINGLEREMOTECONTROL4ODOSOYOUHAVETOASSIGNAN)$NUMBERTOEACHPROJECTOR
CONTROL ID NUMBER .......Select a number from 1 to 254 you wish to assign to your projector.
CONTROL ID .......................Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-
ting.
./4%
s 7HEN;/.=ISSELECTEDFOR;#/.42/,)$=THEPROJECTORCANNOTBEOPERATEDBYUSINGTHEREMOTECONTROLTHATDOESNOTSUPPORT
THE#/.42/,)$FUNCTION)NTHISCASETHEBUTTONSONTHEPROJECTORCABINETCANBEUSED
s 9OURSETTINGWILLNOTBEAFFECTEDEVENWHEN;2%3%4=ISDONEFROMTHEMENU
s0RESSINGANDHOLDINGTHE%.4%2BUTTONONTHEPROJECTORCABINETFORSECONDSWILLDISPLAYTHEMENUFORCANCELINGTHE#ONTROL
)$
!SSIGNINGOR#HANGINGTHE#ONTROL)$
 4URNONTHEPROJECTOR
 0RESSTHE)$3%4BUTTONONTHEREMOTECONTROL
The CONTROL ID screen will be displayed.
If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the projector
cannot be operated with the current remote control ID, the [INACTIVE] will be displayed. To operate the inactive
projector, assign the control ID used for the projector by using the following procedure (Step 3).
 0RESSONEOFNUMERICKEYPADBUTTONSWHILEPRESSINGANDHOLDINGTHE)$3%4
BUTTONONTHEREMOTECONTROL
%XAMPLE
To assign “3”, press the “3” button on the remote control.
No ID means that all the projectors can be operated together with a single remote
control. To set “No ID”, enter “000” or press the CLEAR button.
4)04HERANGEOF)$SISFROMTO
 2ELEASETHE)$3%4BUTTON
The updated CONTROL ID screen will be displayed.
./4%
s4HE)$SCANBECLEAREDINAFEWDAYSAFTERTHEBATTERIESARERUNDOWNORREMOVED
s!CCIDENTALLYPRESSINGANYONEOFTHEBUTTONSOFTHEREMOTECONTROLWILLCLEARCURRENTLYSPECIlED
)$WITHBATTERIESREMOVED