NEC MultiSync FE2111SB

12
Specifications
Monitor MultiSync
®
FE2111SB
™
Notes
Specifications Monitor
Picture Tube Diagonal: 22 inch/55 cm 90° deflection, 0.24 mm grille pitch,
Viewable Image Size: 20 inch/508 mm medium short persistence phosphor,
Radius: 50000 mm aperture grille CRT, G-WARAS coating
Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms
Sync: Separate sync. TTL Level
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
Composite sync. (Negative) (TTL Level)
Display Colors Analog input: Unlimited number of Colors Depends on display card used.
Synchronization Horizontal: 30 kHz to 115 kHz Automatically
Range Vertical: 50 Hz to 160 Hz Automatically
Resolutions Supported 640 x 480 @ 50 to 160 Hz
Some systems may not support
Resolution based on
horizontal and 800 x 600 @ 50 to 160 Hz all modes listed.
vertical frequencies only 1024 x 768 @ 50 to 138 Hz
1280 x 1024 @ 50 to 105 Hz
1600 x 1200 @ 50 to 91 Hz
...................... NEC-Mitsubishi Electronics Display cites
1800 x 1350 @ 50 to 81 Hz recommended resolution a 85 Hz for
1800 x 1440 @ 50 to 76 Hz optimal display performance.
1856 x 1392 @ 50 to 79 Hz
1920 x 1440 @ 50 to 76 Hz
Active Display Area Horizontal: 396 mm/15.6 inches Dependent upon signal timing used,
(Factory Setting) Vertical: 297 mm/11.7 inches and does not include border area.
Active Display Area 406 mm/16.0 inches Dependent upon signal timing used,
(Full Scan) 304.6 mm/12.0 inches and does not include border area.
Power Supply AC 100 – 120 V/220 - 240 V, 50/60 Hz
Current Rating 1.25A @ 100 – 120 V / 0.6A @ 220-240 V
Dimensions
495 mm (W) x 484.5 mm (H) x 471 mm (D)
19.5 inches (W) x 19.1 inches (H) x 18.5 inches (D)
Weight 29.0 kg
64.0 lbs
Environmental Considerations
Operating Temperature: +5°C to +35°C/+41°F to +90°F
Humidity: 10% to 90%
Altitude: 0 ft (0 m) ~ 10,000 ft (3,000 m)
Storage Temperature: -20°C to +60°C/-4°F to +140°F
Humidity: 10% to 90%
Altitude: 0 ft (0 m) ~ 50,000 ft (15,000 m)
NOTE: Technical specifications are subject to change without notice.