11
the last touch of a
button to shut off the OSM control menu. The preset choices are
10, 20, 30, 45, 60 and 120 seconds.
OSM LOCK OUT: This control completely locks out access to all OSM control
functions except BRIGHTNESS and CONTRAST. When attempting to activate
OSM controls while in the Lock Out mode, a screen will appear indicating the
OSM controls are locked out. To activate the OSM Lock Out function, press +
key, then SELECT and hold down simultaneously. To deactivate the OSM Lock
Out, press + key, then SELECT and hold down simultaneously.
OSM ROTATION: To rotate OSM between Landscape and Portrait modes.
RESOLUTION NOTIFIER: This optimal resolution is 1280 x 1024. If ON is
selected, a message
will appear on the screen after 30 seconds, notifying you
that the resolution is not at
1280 x 1024
.
HOT KEY: You can adjust the brightness and contrast directly. When this
function is set to ON, you can adjust the brightness with or , contrast with
+ or - key, while the OSM menu is off.
FACTORY PRESET: Selecting Factory Preset allows you to reset most OSM
control settings back to the factory settings. Individual settings can be reset by
highlighting the control to be reset and pressing the RESET button.
Information
DISPLAY MODE: Provides information about the current resolution display and
technical data including the preset timing being used and the horizontal and
vertical frequencies. Increases or decreases the current resolution.
MONITOR INFO: Indicates the model and serial numbers of your monitor.
OSM Warning: OSM Warning menus disappear with Exit button.
NO SIGNAL: This function gives a warning when there is no Horizontal or
Vertical Sync. After
power is turned on or when there is a change of input
signal, the No Signal window will appear.
RESOLUTION NOTIFIER: This function gives a warning of use with optimized
resolution. After power is turned on or when there is a change of input signal or
the video signal doesn’t have proper resolution, the Resolution Notifier window
will open. This function can be disabled in the TOOL menu.
OUT OF RANGE: When the input signal is a non-supported timing or the
video signal doesn’t have proper timing, the Out Of Range menu will
appear.
NOTE: If “ CHANGE DVI SELECTION” is displayed, switch to DVI
SELECTION.
For advanced user menu see “Appendix”.
Controls –continued
To Next Page
Loading...
Need help?
General