7
Quick Start –continued
Long Cable Compensation Adjustment
To perform the long cable compensation adjustment, use the following steps:
Set the Auto Adjust Level (Auto SW) to “DETAIL” in the Advanced OSM
To enter the Advanced OSM
•Turn off your monitor.
•Turn on your monitor by pressing the “POWER” and “SELECT” buttons
simultaneously to open the Advanced OSM menu.
To exit the Advanced OSM
•Turn off and restart your monitor.
Perform “AUTO ADJUST” by using
OSM AUTO
• Use the Long Cable software
CD-ROM (included) during adjustment.
• Press SELECT to adjust.
SIMPLE X
FULL X
DETAIL
"Size" "Fine"
"Position"
O
O
O
X
O
OO
1.5 seconds
2 seconds
10 to 20 seconds
Time
"
Contrast"
Long cable capability *1
Black Level,
O: Automatic adjustment is performed.
X: Automatic adjustment is not performed.
*1: Black level, RGB sharpness, RGB delay and RGB position are adjusted using Long Cable Software (included).
To Next Page
Loading...
Need help?
General