NEC N8181-153 - Page 16

16
3-3. Remove two power cables from the power connector on the motherboard.
3-4. Connect the I2C cable of the control kit to the I2C connector on the motherboard.
3-5. Connect two power cables that removed in step 3-3 to connector on the control kit.(Indicated by
circle on the figure)
Please refer step 7-4 for detailed power
connector location on the motherboard.
Rear Side
Front Side
Motherboard
I2C Cable
Please refer step 7-4 for detailed I2C
connector location on the motherboard.
I2C Connector
Control kit
P2 Connector
P1 Connector