3-6. Connect two power cables of control kit to the power connector on the motherboard you removed
in step 3-3.
4. Install the LED cable to the device tray you removed in step2.
4-1. Attach the bracket of the LED cable to the right edge of the device tray.
4-2. Fix with a flat-head screw.
4-3. At the position marked in the figure, fix the LED cable to device tray with a cable tie.
(Pass through a cable tie by two holes in the figure.)
If backup device is already installed in
3.5-inch expansion bay(2), use the
device tray attached in this product.
To Next Page
Loading...
