NEC RSH2423S - Cooling Operation

Safety Precautions
Operating Instructions
Care and Maintenance
Troubleshooting Tips
10
To raise the temperature
To lower the temperature
Cooling Healthy
Dehumidification
Auto Heating
(Heat pump model only)
How to use the Operation Mode Selection button
Press the Start/Stop button. The unit will respond with a beep.
Open the door on the remote control. To select Cooling
Operation, press the Operation Mode Selection button.
Each time the button is pressed, the operation mode is shifted
in the direction of the arrow.
Close the door on the remote control. Set the temperature
lower than the room temperature. The temperature can be set
within a range of 18°C~30°C in 1°C increments.
Set the fan speed again with the door of the remote control
still closed. You can select the fan speed in four steps-low,
medium, high, or CHAOS. Each time the button is pressed,
the fan speed mode is shifted.
Cooling Operation
1
2
3
4
(1) A30045A(wfl+) 1994.10.12 12:36 PM ’. 3 310