TERMINAL SETUP
31
TO ENABLE/DISABLE DTMF TONE
The procedure below shows how to enable/disable DTMF Tone.
1.
Press Menu key while terminal is in an idle state.
2.
Select
□
1 User Settings.
3.
Select
□
2 Talk.
4.
Select
□
2 DTMF Tone
5.
Select
□
0 Automatic,
□
1 Disable or
□
2 Enable
(see the following table).
Follow the setting on the System.
If no setting is made in the System, the
default setting (DTMF=ON) is applied.
Follow the setting on the terminal (OFF).
Follow the setting on the terminal (ON).
■For the setting on the System, contact the system
administrator.
■The enabled item is highlighted.
TO SET KEY TOUCH TONE
The procedure below shows how to set Key Touch Tone. Key
Touch Tone is a tone generated when the digit keys are pressed
while the terminal is off-hook.
1.
Press Menu key while terminal is in an idle state.
2.
Select
□
1 User Settings.
3.
Select
□
2 Talk.
4.
Select
□
3 Key Touch Tone.
5.
Select
□
0 Automatic,
□
1 Disable or
□
2 Tone.
■When
□
0 Automatic is set, the default setting is applied.
■The enabled item is highlighted.
To Next Page
Loading...
