FAN SERVICE
To provide years of trouble free operation the fan motor bearings are factory
lubricated. However, damage can occur if dust or lint builds up in blades.
Therefore the fan assembly should be inspected and cleaned each year.
1. Turn off power and disconnect power lead.
2. Brush or vacuum fan blades taking care not to damage the blades.
3. Plug in power and turn on.
CLEANING THE FIREBOX
Ash should be cleared or removed when build up reaches the level of the door
opening.
To clean, use a metal fireplace shovel making sure all deposits are cold first.
Do not place hot ashes of coals in plastic rubbish bin.
CONTROLS
AIR SLIDE
Moving the air slide to the left enables maximum air into the firebox. Moving
air
slide to the right closes off air into the firebox, which slows the burn down.
FAN SWITCH
4 position switch with 3 speeds - High, Medium, Low.
To Next Page
