ANPR LUMO | QUICK REFERENCE GUIDE
5/6
CONFIGURE THE ANPR
By default the camera’s exposure settings are pre-configured to suit most situations, The following items needs to
be configured after installation.
- Region of interest
- Output messages (actions)
Drive the vehicle into the position where it should be possible to read it's license plate. Connect to the ANPR using
your web browser and login. After a successful login you will see the live video in the menu item “HOME”. On the
right side of the page 'live' text results are shown. It might be necessary to adjust the ANPR alignment.
The Yellow box within the LIVE VIEW represents the region of interest, this region of interest can be changed in the
configuration menu.
Region of interest
After correct installation of the camera, it is recommended to change the region of interest. This can be done by
moving the green points to the desired position. Press the “Apply” button next to the corresponding item to
permanently store the region of interest.
For more details about the menu items, see the installation guide on https://portal.nedapidentification.com
To Next Page
Loading...
Need help?
General