Need help?Do you have a question about the Nedap i30 and is the answer not in the manual?
General| Type | RFID Reader |
|---|---|
| Detection Method | RFID |
| Connectivity | RS-485 |
| Communication Interface | RS-485 |
| Operating Temperature | -20°C to +50°C |
Details the connectors on the Renos unit and their intended usage.
Rules for combining gates into systems based on role and synchronization.
Provides recommendations for aisle width and label-free zones for optimal detection.
Outlines the required Ethernet and RFID coaxial cables for system setup.
Explains how to connect and manage the system remotely via Device Management.
Instructions for orienting gates correctly due to RFID antenna sensitivity.
Covers placement of cables and filters to reduce interference and ensure proper function.
Instructions for connecting a laptop to the Renos unit for configuration.
Guides users to access the system's configuration wizard via a web browser.
Step-by-step guide for performing a factory reset on a Renos unit.
Describes methods for updating the system's firmware.
Troubleshooting common issues related to physical installation and LEDs.
To Next Page
