nedis BTTC200BK - Page 9

9
Transmitter mode (image D)
Option 1:
1. Set the AUX / SPDIF switch A
1
to AUX.
2. Set A
7
to TX.
3. Plug B
r
into A
8
.
4. Plug the other end of B
r
into your audio source.
4
You can also connect an audio device with the stereo audio cable 2x RCA
male to 3.5 mm female B
e
.
Option 2:
1. Set the AUX / SPDIF switch A
1
to SPDIF.
2. Set A
7
to TX.
3. Plug B
y
into SPDIF input (Tx) A
9
.
4. Plug the other end of B
y
into your audio source.
5. Switch on the product.
A
6
Blinks green.
6. Keep your Bluetooth audio device within range and switched on.
4
Pairing time will vary depending on the device used.
4
A
6
Burns to indicate pairing is successful.
Connect a second device
• After successfully connecting the first device, press A
5
again to pair to a
second device.
4
The devices must be one meter apart from each other.
4
The two devices are connected simultaneously.
4
If the pairing does not work, switch the product off and on.
Disconnect paired devices
• Press and hold A
5
for 3 seconds.
4
To disconnect a single device, switch off the Bluetooth of that device.