24 EN Operating Instructions
7.1 AUTOMATIC operating mode
In AUTOMATIC operating mode, the laser automatically levels itself horizon-
tally within a range of ±5° and compensates for minor vibrations.
Switch on the laser Laser levels itself
horizontally
Levelling is finished, the flashing symbol goes
out, the laser is active
During and for 30 seconds after the levelling the laser can be placed in the fi-
nal vertical position/height without warning, e.g. using an elevator tripod.
After 30 seconds, the TILT alarm function is switched on. A vertical move-
ment of the laser triggers the warning C01. For description and remedies, see
Chapter 9.
AUTOMATIC operating mode is active. The following functions can be
invoked:
Use the
button to switch to MANUAL operating mode (Chapter 7.2).
Use the
button to exit the operating mode, switch off the laser.
7.2 MANUAL operating mode
In MANUAL operating mode the laser does not detect any vibrations and
does not level itself horizontally.
AUTOMATIC opera-
ting mode is active
Set MANUAL opera-
ting mode
The hand symbol is
displayed
NOTE
Use the button to switch to MANUAL operating mode immediately after switching
on
.
MANUAL operating mode is active. The following functions can be invoked:
Use the
button to switch to AUTOMATIC operating mode (Chapter 7.1).
Use the button to exit the operating mode, switch off the laser.
To Next Page
Loading...
Need help?
General
