en Installation instructions
32
3.
Open the appliance door and unscrew the left and
right-hand panels.
4.
Close the appliance door.
5.
Screw the appliance into place.
6.
For handleless kitchens with vertical bar handle
strips:
‒ Attach a suitable filling piece in order to cover
any sharp edges and to guarantee a safe install-
ation.
‒ Pre-drill aluminium profiles to establish a screw
connection .
‒ Secure the appliance using a suitable screw .
7.
Refit the panels and screw them in place, first at the
top and then at the bottom.
8.
If required, the gap between the appliance door and
the side panels can be adjusted using the screws at
the top left and right.
Note:The gap between the worktop and the appliance
must not be closed by additional battens.
Thermal insulation strips must not be fitted to the side
panels of the surround unit.
21.10 Removing the appliance
1.
Disconnect the appliance from the power supply.
2.
Open the appliance door and unscrew the left and
right-hand panels.
3.
Undo the fastening screws.
4.
Lift the appliance slightly and pull it out completely.
To Next Page
Loading...
Need help?
General
