Appliance door en
35
Removing panels
1. Press on the left- and right-hand sides of the cover
(fig.°!).
2. Remove the cover (fig. ").
3. Lift out the inner panel (fig. #) and set it down
carefully on a flat surface.
4. Take off the seal on both sides and remove it
(fig. $).
5. Lift out the intermediate glass panel (fig. %) and set
it down carefully on a flat surface.
6. If necessary, you can remove the condensate trough
for cleaning. To do this, open the appliance door
fully (fig. &).
7. Tilt the condensate trough up and remove it (fig. ').
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
:Warning
Risk of injury!
■ Scratched glass in the appliance door may develop
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
Risk of injury!
■ The hinges on the appliance door move when
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Fitting panels
1. Open the appliance door fully and refit the
condensate trough. To do this, insert the trough from
above and rotate it at the bottom (fig. !).
2. Slide the intermediate glass panel back in and make
sure that it is sitting correctly at the bottom in the
retainer (fig. ").
2
1
1
2
To Next Page
Loading...
Need help?
General
