ImportAppliances.com
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
en Operating the appliance
8
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the 6 symbol.
Setting the brightness
Press and hold the 6 symbol until the required
brightness is reached.
Saturation display
If the metal grease filters or the activated charcoal filter
are/is saturated, the corresponding symbols flashes
after the appliance is switched off:
■ Metal grease filter: ”ª
■ Activated charcoal filter: ’ª
■ Metal grease filter and activated charcoal filter:
ӻ and ջ
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 9
Note: The saturation indicator does not apply for non-
renewable activated charcoal filters that are inserted
downstream of the metal grease filter. These activated
charcoal filters must be replaced twice a year.
The saturation indicators can be reset while they are
flashing. To do this, touch the ( symbol.
Switching over the display for air circulation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■ The extractor hood must be connected and switched
on.
■ Touch and hold the Q symbol and touch
the ( or ) symbol until "2" lights up for air
recirculation mode (filters that cannot be
regenerated). Take your finger off the Q symbol.
This will switch the electronic controller over to air
recirculation mode (filters that cannot be
regenerated).
■ Touch and hold the Q symbol and touch
the ( or ) symbol until "3" lights up for air
recirculation mode (filters that can be regenerated).
Take your finger off the Q symbol. This switches the
electronic controller over to air recirculation mode
(filters that can be regenerated).
■ Repeatedly touching and holding the Q symbol and
touching the ( or ) symbol until "1" lights up switches
the electronic controller back over to air extraction
mode.
Audible signal
Switching on
Touch and hold the # and Q symbols at the same
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
When the signal tone is activated, ‚ will be lit.
Switching off
Touch and hold the # and Q symbols at the same
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
When the signal tone is deactivated, ‹ will be lit.
To Next Page
Loading...
