en
Ú
Installation instructions
You must note the following
Electrical connection: Must only be carried out by a licensed
expert. Incorrect connection will invalidate the warranty.
Installation: Must only be carried out by a professional. The
fitter is liable for any damage.
Hob and cooker: Must only be from the same brand and have
the same combination feature.
Protection against accidental contact: Must be ensured
through the manner of installation.
Installation instructions: Must be observed for the cooker.
Work surface: Level, horizontal, stable.
Preparing the units - Figure 1
Fitted unit: Heat resistant to at least 90 °C.
Cut-out: Minimum distance to the side walls: 90 mm.
After cutting the necessary holes in the work surface, remove
the shavings.
If parts on the underside of the hob touch adjacent units, an
intermediate floor with 5 mm clearance to the underside of the
hob must be fitted.
Cut surfaces: Seal with heat-resistant material.
Attaching securing rails - Fig. 2
Tiled work surfaces:: Use the lower screw holes.
Granite or marble work surfaces: Insert wall plugs or sockets
for the securing screws or affix securing rails.
Connecting the hob - Figs 3 and 4
The cooker must be connected to the mains, but switched off.
Put the hob down as shown in Fig. 3.
1. Screw the hob's PE conductor (green/yellow) onto the cooker
earthing point <.
2. Plug the hotplate plug into the cooker - see Fig. 4. The colour
of the cable must correspond to the colour shown on the label.
The lug N on the plug must point to the left.
Fitting the hob - Fig. 5
Cables: Do not trap cables when fitting.
Push the hob in until it locks into place.
Tiled work surfaces: Seal the tile joints with silicone rubber.
Removing the hob
Disconnect the appliance from the power supply.
Pull out the cooker a short distance. Unplug the cooking zone
plug. Finally, disconnect the PE conductor (green/yellow) from
the earthing screw.
Push out the hob from below.
To Previous Page
Loading...
Need help?
General
