Troubleshooting en
43
Fault Cause Troubleshooting
Tableware is not dry. Programme or programme
option has no drying phase,
or the drying phase is too
brief.
▶ "Select a programme with drying,
e.g. intensive, strong or ECO pro-
gramme." →Page17
Some option buttons decrease the
drying result, e.g varioSpeed.
Water collects in recesses of
the tableware or cutlery.
▶ Position tableware at an angle
where possible.
The combined detergent
used has a poor drying per-
formance.
1. Use rinse aid to improve drying per-
formance.
2. Use a different combined detergent
with a better drying performance.
Extra Dry not activated to im-
prove drying performance.
▶ Activate Extra Dry.
Tableware removed too
early or drying process not
yet ended.
1. Wait until the programme ends.
2. Only remove tableware 30minutes
after the programme has ended.
Rinse aid used has a limited
drying performance.
▶ Use a name-brand rinse aid.
Eco products may have limited ef-
fectiveness.
Plastic tableware is not dry. Not a fault. As plastic does
not store heat so well, it also
does not dry as well.
▶ No remedial action possible.
Cutlery is not dry. Cutlery not arranged prop-
erly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery con-
tact points.
1. "Arrange cutlery individually where
possible." →Page29
2. Avoid points of contact.
To Next Page
Loading...
Need help?
General
