Switching the dishwasher off
Several minutes after the programme has ended:
• Open the door when the programme has ended
• Set the main switch to OFF
• Remove dishes etc when they have cooled down
Programme interruption
• Carefully open the door, and only open completely when the spray arm is no longer turning. If the
programme is already in ‘drying’ mode, a noise will signal to remind you to close the appliance door or
to abort the programme
• Switch OFF the main switch
• Indicator light will go out and the programme will remain stored
• In order to continue with the programme, switch the main switch ON again and close the door
Cancel Programme (Reset)
• Only when the master is ON. Press the and programme buttons at the same time and hold
them down for approximately 3 seconds
• The programme continues for approximately 1 minute. The PROGRAMME END indicator for the
programme that has just been terminated light up
• Set the main switch to OFF
Changing the programme
• It is possible to change the programme selection after you have switched the dishwasher on,
provided that you have not yet closed the door. If it is necessary to change the programme after this,
the programme cycle that has already begun will still carry on to the end.
To Previous Page
Loading...
