Troubleshooting
Q: Why are the labels not aligned properly?
A: Change the paper type on the app. Realign the printer by pressing
the Power/ Feed button once.
Q: Why are the labels not printing clearly?
A: Check and adjust the printing density. If there is a line or blank area
on the label, check if the print head is clean. If not, clean it with alcohol.
Low quality paper may also introduce problems. For best results, use
label paper offered by printer manufacturer.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesired Operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause 17 harmful
interference to radio or television reception, which can be determined
by tuming the equipment off and on, the user is encouraged to try to
correct the interference by one or more Of the following measures:
—Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure
requirement.
The device can be used in portable exposure condition without
restriction.
To Next Page
Loading...