To Next PageTo Next PageWhy does my NEO TOOLS Jack not reach its lift capacity?
If your NEO TOOLS Jack isn't reaching its lift capacity, it might be due to air in the system. Try opening the release valve and pumping the jack lever a few times, then close the release valve. Repeat as needed to bleed the air out.
What to do if NEO TOOLS Jacks valves are blocked?
If your NEO TOOLS Jack isn't reaching its lift capacity, it could be due to valves being blocked by a foreign object. To resolve this, flush the valves. Then, lower the piston rod and close the release valve. Manually pull the piston rod out by over 10 cm (4 inches). Open rod to down position.
Information on the product manufacturer, including address.
Product name, model numbers (11-730, 11-731), and serial number range.
Conformance to EU directives and relevant safety standards.
Contact person for technical documentation within the EU.
Essential safety guidelines and warnings for operating the hydraulic jack.
Lists and identifies the main parts of the hydraulic jack.
Specific safety instructions for lifting vehicles and safe jack operation.
Steps to prepare the jack for operation, including lever assembly.
Step-by-step guide on how to safely lift a load with the hydraulic jack.
Step-by-step guide on how to safely lower a load with the hydraulic jack.
Procedure to remove air from the hydraulic system for optimal performance.
Guidelines on how to protect the jack from humidity and prevent corrosion.
Identifies common problems and their potential causes for the hydraulic jack.
Key technical parameters: capacity, height range, and weight.
General