2. ON/OFF
Press ON/OFF button to turn the equipment on. And it
shows the last mode before shutdown. Hold ON/OFF button
not to put to turn it off.
After about 3 minutes not using the equipment, it will switch
off automatically.
3.Turn on the equipment and put it to the level position for
measuring.
2
Operation instructions
1. Battery replacement
Remove the rear battery cover of the receiver by
unscrewing the battery cover retaining screw. The cover
will now lift off. Open the battery case. Put two “AAA”
batteries and close the case. Your electronic level is now
ready to use.
To Next Page
Loading...