11
EN
Cleaning instructions
Unplug the power cord from the
power outlet before cleaning.
Remove silicon seal from lid.
Dissemble all part of the whisk, by
gently turning the upper whisk part
to remove it.
Remove the whisk. For an optimal
cleaning, make sure to dissemble
both part of the whisk.
Hand washing: wash inner jug,
seal, lid and whisk with detergent
and rinse with warm/hot water.
Do not use abrasive material that
might damage the surface of the
equipment. Make sure to remove
the warning label before cleaning
the whisk.
Dishwashing: put all parts except
the power base in the dishwasher at
maximum 70°C.
Wait for the jug to cool down and
remove the milk jug from the power
base.
CAUTION: Ensure the jug is cold before removing it from the power base. Or, if
removing with care, rinse with cold water immediately to cool down the jug and
avoid burning risks. / In case the power base needs to be cleaned unplug it first
and use only a damp cloth. Make sure the connector is dry before operation.
Do not immerse the power base in water neither put in the dishwasher. / Do
not place directly over the dishwasher pin as it may cause damage to inner
surface. / If the bottom part of the jug is wet, dry it before putting it back
in contact with the power base station. / Only use non-abrasive cleaning
materials. Do not use abrasives, sharp objects, brushes: risk of scratches
and harm to the jug surface.
Clean directly after every use
To Next Page
Loading...
Need help?
General
