Nespresso C140 - Troubleshooting

FR
PANNES
DE
FEHLERBEHEBUNG
IT
RISOLUZIONE PROBLEMI
ES
RESOLUCIÓN DE PROBLEMAS
PT
RESOLUÇÃO DE PROBLEMAS
DA
FEJLFINDING
NO
FEILSØKING
SV
FELSÖKNING
FI
VIANMÄ ÄRITYS
CS
ŘEŠENÍ PROBLÉMŮ
SK
RIEŠENIE PROBLÉMOV
PL
ROZWIĄZYWANIE PROBLEMÓW
HU
HIBAELHÁRÍTÁS
RU
УСТРАНЕНИЕ НЕИСПРАВНОСТЕЙ
EL
ΑΝΤΙΜΕΤΩΠΙΣΗ
ΠΡΟΒΛΗΜΑΤΩΝ
NL
PROBLEMEN OPLOSSEN
RO
DEPANARE
30
7
TROUBLESHOOTING
EN
No light indicator • Check the power outlet, plug, voltage, and fuse. In
case of problems, call Nespresso.
No coee, no water • First use: fill water tank with warm water
(max. 55 °C / 130 °F) and run through machine
according to instructions on page 11.
• Water tank is empty. Fill water tank.
• Descale if necessary; see Descaling section.
Coee comes out very slowly • Flow speed depends on the coee variety.
• Descale if necessary; see Descaling section.
Coee is not hot enough • Preheat cup.
• Descale if necessary; see Descaling section.
Capsule area is leaking
(water in capsule container)
• Position capsule correctly. If leakages occur, call
Nespresso.
All beverage buons blinking fast • Machine is in error, overheating or in an environment
below 0°C / 32°F. Please wait for all buons to stop
blinking, this may take a few minutes. If buons still
blink aer a few minutes, unplug and replug the
machine.
• If problem persists, call Nespresso.
Descaling alert blinks during coee
making (descaling alert level 1)
• Machine triggers descaling alert according
beverages consumption usage. Descale machine.
Descaling alert steady light
(descaling alert level 2)
• Machine triggers descaling alert according
beverages consumption usage. Descale machine
immediately to avoid machine performance and
coee quality decrease.
Irregular blinking • Send appliance to repair or call Nespresso.
No coee, just water runs out
(despite inserted capsule)
• In case of problems, call Nespresso.
Coee drops in hot water preparation • Eject any remaining used capsule into the used
capsule container.
• Perform hot water preparation with lever in upward
position.
UM_NEW LAYOUT_ORIGINAL 2_1.indd 30UM_NEW LAYOUT_ORIGINAL 2_1.indd 30 31.01.22 10:5431.01.22 10:54