pg. 7 TQM_057 Effective: September 2016
Lift both water tanks away from the machine and fill the left side tank with 2
litres of water and the right side tank with 1 litre of water.
Empty 4 pouches of descaling liquid in left side tank and 2 pouches in the
right side tank.
(For CS200 and CS100, fill 1 litre of water in each tank and empty 2
pouches in each tank)
NOTE: The water capacity for the following machines are listed below:
For CS100,
For CS200,
For CS220,
Put the tanks back on the machine and push any button. Descaling will begin
automatically.
If the descaling does not begin, lift both water tanks for few seconds, put them
back on the machine and push a button.
The machine should start descaling.
Descaling will continue
~ 3 min, liquid will flow through the plastic tube
~ 20 secs idle time
~ 90 secs liquid will flow through the steam line
~20 secs idle time
Then liquid will flow through the coffee nozzles
Automatic stop and FILL WATER will display
Discard all the liquid in the descaling tray.
Rinse and place back on top of the machine’s drip trays.
Clean and rinse both the tanks and fill them with clean water.
Put the water tanks back on the machine.
Push a button to begin the rinsing process.
The machine will start rinsing
~90 secs liquid will flow through the plastic tube
~15 secs idle time
~40 secs liquid will flow through the steam line
~20 secs idle time
Then liquid will flow through the coffee nozzles
Automatic stop and EXIT, PUSH A BUTTON will display. Push any cup
button to exit.
The machine is now ready to use.
To Next Page
Loading...
Need help?
General
