Nespresso KRUPS VERTUO NEXT NERO XN9108 User Manual

EN
.
31
Light blinks while
machine is running
• If coee is flowing normally, this indicates
the machine is working properly.
• If only water is flowing, the machine is
executing a user request for either cleaning,
descaling or emptying the system. R Please
refer to the corresponding chapter
• Turn the machine to “OFF mode” by
pushing the buon for 3 seconds and then
push it again to turn the machine ON. Now
wait approximately 20 minutes to allow the
machine to cool down aer extensive use.
Light blinks and
machine is not running.
• It will take some time before the coee flow
comes out (due to barcode reading and
pre-weing the coee).
• Check that a fresh capsule is inserted in
correct position, that the lever is properly
locked and push the buon to start.
• Fill the water tank and press the buon to
start.
• Turn the machine to “OFF mode” by
pushing the buon for 3 seconds and then
push it again to turn the machine ON. Now
wait approximately 20 minutes to allow the
machine to cool down aer extensive use.
Light blinks alternately
2 blinks and 1 pause
continuously. Machine is
not running.
• During regular Coee/Espresso
preparation:
1) Unlock the lever and open the machine
head to check that a fresh undamaged
capsule is inserted in the correct position.
2) Check that the lever is in “LOCKED”
position.
3) Check that the water tank is filled.
• During Descaling, Emptying and Cleaning:
1) Check that capsule is ejected.
2) Check that the lever is in “LOCKED”
position.
• During Programming Volume:
1) Check if a capsule has been well inserted.
2) Please refer to the corresponding
chapter
TROUBLESHOOTING  PAGE 2/3

Nespresso KRUPS VERTUO NEXT NERO XN9108 Specifications

General

Brand	Nespresso
Model	KRUPS VERTUO NEXT NERO XN9108
Category	Coffee Maker
Language	English