Nespresso LATTISSIMA PRO - User Manual

My
Machine
*
* Ma machine

Summary

Overview

Rapid Cappuccino System (R.C.S.)

Lists parts of the Rapid Cappuccino System (25-34).

Content

Menu navigation

Explains how to navigate the machine's menus.

First use OR AFTER A LONG PERIOD OF NON-USE

Instructions for first use or after a long period of non-use.

Coffee Preparation

Instructions for preparing coffee.

Assembling;disassembling of Rapid Cappuccino system (R.C.S.)

Instructions for assembling and disassembling the RCS.

Preparing cappuccino AND latte macchiato

Instructions for preparing milk-based drinks.

Daily care

General daily cleaning and maintenance instructions.

Hand washing of Rapid Cappuccino System (R.C.S.)

Specific instructions for hand washing RCS components.

Descaling

Instructions for descaling the machine.

Water hardness setting

Instructions for setting water hardness.

Troubleshooting

Solutions for common problems.

Menu list

FIRST USE OR AFTER A LONG PERIOD OF NON-USE

COFFEE PREPARATION

1. Lift the lever completely and insert a Nespresso capsule.

Step to insert a coffee capsule.

2. Close the lever and place a cup under the coffee outlet.

Steps to prepare for coffee brewing.

3. Press the Ristretto (25 ml), Espresso (40 ml) or the Lungo (110 ml) button. Preparation will stop automatically. To stop the coffee flow or top up your coffee, press again.

Instructions for starting coffee preparation.

4. Take the cup. Lift and close the lever to eject the capsule into the used capsule container.

Steps to remove the used capsule.

ASSEMBLING;DISASSEMBLING OF RAPID CAPPUCCINO SYSTEM (R.C.S.)

1. Remove the milk container lid and unplug milk aspiration tube.

2. Remove the milk froth regulator knob by turning it until and pulling it up.

3. Remove Rapid Cappuccino System connector by unlocking it from to and pulling it off.

4. Remove the milk spout by pulling it off.

Preparing Cappuccino and Latte Macchiato

1. Fill the milk container with desired quantity of milk.

5. Close the lever, place a Cappuccino cup or a Latte Macchiato glass under the coffee outlet and adjust milk spout position.

2. Close the milk container. Open the steam connector door by sliding it to the right. Connect the Rapid Cappuccino System to the machine.

6. Adjust the milk froth regulator knob according to the volume of froth you want.

7. Press the Cappuccino or Macchiato button. The preparation starts after a few seconds (first milk and then coffee) and will stop automatically.

4. Lift the lever completely and insert a Nespresso capsule.

8. At the end of the preparation, lift and close the lever to eject the capsule into the used capsule container.

10. Rotate the milk regulator knob in CLEAN position. Milk system rinsing process starts and hot water combined with steam flows through the milk spout.

DAILY CARE

INFORMATION: do not use any strong cleaning agent or solvent cleaner. Use a clean damp cloth and mild cleaning agent to clean the surface of the machine. Do not put any machine components in dishwasher, except the Rapid Cappuccino System components.

HAND WASHING OF RAPID CAPPUCCINO SYSTEM (R.C.S.)

INFORMATION: when a dishwasher is not available, the R.C.S. components can be washed manually. In that case, the procedure must be performed daily for a maximum efficiency.

1. Remove drip tray, capsule container. Empty and rinse. Remove water tank. Empty, rinse it before filling with fresh potable water.

1. Disassemble the Rapid Cappuccino System. Refer to section Assembling;Disassembling of Rapid Cappuccino system (R.C.S).

2. Rinse away carefully any milk residue with potable water.

3. Soak all components in warm water (approximately 40° C) together with soap detergent for at least 30 minutes.

4. Rinse with potable water and dry them with a clean damp cloth.

VOLUME FACTORY SETTINGS

Cappuccino Milk*: 50 ml;Coffee: 40 ml

Latte Macchiato Milk*: 150 ml;Coffee: 40 ml

CAUTION: if coffee volumes higher than 150 ml are programmed: let the machine cool down for 5 minutes before making the next coffee. Risk of overheating!

Warning about high coffee volume settings and overheating.

DESCALING

1. Lift and close the lever to eject any capsule in the used capsule container.

2. Enter the Menu, browse the options and select [DESCALING]. You will be guided throughout the whole process. Follow machine display instructions.

Instructions for initiating the descaling process via the menu.

3. Descaling process: empty the drip tray and the used capsules container.

4. Descaling process: fill water tank with 100 ml of Nespresso descaling agent and 500 ml of potable water.

Instructions for preparing the descaling solution.

5. Descaling process: insert the hot water spout.

6. Descaling process: place one container of minimum 1 litre under both the coffee outlet and the hot water spout.

7. Press to confirm. The descaling agent flows alternately trough the coffee outlet, hot water nozzle and drip tray.

8. Rinsing process: empty the drip tray and the used capsules container. Rinse with potable water.

WATER HARDNESS SETTING

1. Enter the menu, browse the options and select [WATER HARDNESS]. You will be guided to set the value. Follow machine display instructions.

2. Place the water hardness sticker under water for 1 second.

4. Set the value accordingly.

Troubleshooting

No light on display.

Checks for power and display issues.

Machine too hot message, indicated in display.

Addresses overheating messages and automatic cooling.

Coffee comes out very slowly.

Checks coffee flow speed and suggests descaling.

Coffee is not ho t enough.

Suggests preheating the cup and descaling.

Capsule area is leaking (water in capsule container).

Addresses capsule area leaks and suggests checking capsule placement.

Irregular blinking.

No coffee, just water runs out (despite inserted capsule).

Advises contacting Nespresso Club for coffee delivery issues.

Lever cannot be closed completely.

Suggests emptying the capsule container and checking for blockages.

Quality of milk froth is not up to standard.

Provides tips for improving milk froth quality.

Machine needs repair message, indicated in display.

Advises contacting Nespresso for repair or adjustment.

Nespresso LATTISSIMA PRO Specifications

General

Product type	Capsule coffee machine
Built-in grinder	No
Capacity in cups	- cups
Coffee input type	Coffee capsule
Coffee maker type	Fully-auto
Appliance placement	Countertop
Coffee capsule/pod system	Nespresso
Maximum operating pressure	19 bar
Display type	LCD
Product color	Black, Stainless steel
Built-in display	Yes
Housing material	-

Weight and Dimensions

Depth	332 mm
Width	194 mm
Height	374 mm
Weight	6500 g