NESS SIM CARD
REAR PANEL & CONNECTIONS
TEL1
Connect RJ45 lead
from alarm panel.
TEL2
Not used
POWER SWITCH
Must remain on.
POWER INPUT
12VDC from plug
pack supply
RS232 PORT
Not used
How to install the SIM Card. (This may not be
necessary if the SIM card is already installed.)
1. Insert the SIM card. Observe
position of the notch.
3. Slide forward to lock.
2. Close the SIM holder.
ANTENNA CONNECTION
ANTENNA
SOCKET
Connect the antenna cable to the GSM unit and place the antenna as far
as possible from the unit. The antenna is supplied with a 5m cable to allow
positioning of the antenna for best signal reception. Excess cable should be
kept straight and not be coiled to prevent radiant interference.
5m cable
Magnetic base
For your security,
the Ness SIM Card
is locked and cannot
be used in any other
GSM device or mobile phone.
Any attempt unlock or tamper
with the SIM card may render
it inoperable. In this case you
may be charged for a new SIM
card and you may be in breach
of your monitoring contract.
To Next Page
Loading...
Need help?
General
